![]() Forgot to add my reamer has removable pilot so I just put a 30 cal bushing on it.Īlso you should get a striker for a M1917 enfield and change it out after opening the striker opening in bolt face a tad as the M1917 is about. I also had him re-cut the throat and give it a 30.06 throat so the bullet does not have to jump past next Sunday to find the rifling.Īlso I used a take off target barrel from a match rifle and cut the threads off and chambered it for the 303. What I did was I found a used 303 Brit finish reamer and sent it to Dave Manson and had him reduce the body dimension to I think it was. Sizing these cases in a FL die really works the brass and brass will fail quickly. As well the shoulder expands out and forward. Now what you are going to run into is 303 Chambers are designed to park a truck in, they are way larger than needed and you will see a big swell in the base of the case. I did the adaptor all on one set up so the bore center line is dead center on the small bore and both internal and external threads are parallel. I turned a piece of big round stock and threaded outside with P14 threads and then drilled and bored a smaller hole and threaded it 1"X16 so a normal blank could be fitted to it. Note this receiver appears to have a spacer installed and it does. Rebarreling these things can get pricey as the receiver threads are so large that it takes a special oversize blank to make it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |